UKEN

Thank you!

Our manager will contact you as soon as possible

B-3 SLEEVE "STOCK 3 - STEP"

Limestone
description:

В-3 - a limestone mixture with thin fillers for finishing smoothing of surfaces that do not undergo deformations (brick, concrete, aerated concrete, old plaster). For internal and external work.

features:
  • Excellent vapor permeability (the effect of breathing
  •   walls »)
  •   Natural antiseptic
  •   Super smooth surface
  •   White color
order

Usage

В-3 - a limestone mixture with thin fillers for finishing smoothing of surfaces that do not undergo deformations (brick, concrete, aerated concrete, old plaster). For internal and external work.

preparing basis

The substrate must be strong, even, cleaned of dirt, paint and fragile areas. Any surfaces before applying the piece must be treated with silicate primer G-3 or moistened with water.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMMARY В-3 В.2.ШТ6 WHITE DSTU B V.2.7-126
    2011
  • Approximate dilution
    0.8 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,45 - 0,50 l / kg (6,5 - 7,5 l / bag)
  • Shelf life of the mortar
    not less than 24 hours.
  • Recommended thickness of one layer
    up to 1 mm
  • Strength of the clutch with the base
    not less than 0.3 MPa (28 days)
  • Vapor permeability
    not less than 0.05 mg / m x h x Pa
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    paper bags of 15 kg

Apply the mortar with a stainless steel spatula. When working with a conventional spatula, dark strips may appear on the putty surface. After drying, remove the small irregularities by grinding. It is not recommended to delay grinding time for more than 24 hours, since the putty surface is rapidly gaining strength. The final alignment is carried out in a "wet" way: when the surface becomes opaque and when touching does not dirty the finger, lightly sprinkle it with water and with a spatula to smooth it to an ideal condition. Further surface treatment (painting) is recommended not earlier than 7 days.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download