Apply the mortar to the wall with a wide spatula, metal grater or polterkerk. Wipe the surface with a felt or foam float after drying. The time from application to rubbing about 20 minutes, depends on the absorbing ability of the base, the consistency of the mortar mixture and the temperature of the air and is determined visually: with a moderate pressing of the finger, the layer of solution does not shifted and does not remain on the finger. Finish the surface completely with foam rubber stove. If necessary, slightly moisturize the stalk, remove the residue from the solution from time to time. Avoid excessive rubbing and drying the edges of the applied solution, which can lead to heterogeneity of the texture of the surface. Further treatment of the plaster surface (finishing spackling, painting) is recommended not earlier than 7 days.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.