UKEN

Thank you!

Our manager will contact you as soon as possible

В-1 STOCKING "STOCK 1 - START"

Limestone
description:

В-1 - a lime-sand mixture with fillers and micro-reinforcement for the initial alignment of surfaces that do not undergo deformation (brick, concrete, aerated concrete). For internal and external work.

features:
  • Excellent vapor permeability (effect of breathable wall)
  •   Natural antiseptic
  •   With reinforcing fiber
  •   White color
order

Usage

В-1 - a lime-sand mixture with fillers and micro-reinforcement for the initial alignment of surfaces that do not undergo deformation (brick, concrete, aerated concrete). For internal and external work.

preparing basis

The substrate must be strong, even, cleaned of dirt, paint and fragile areas. Any surfaces before applying the piece must necessarily be treated with silicate primer G-3, as instructed, or moistened with water.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMMARY В-1 В.2.ШТ6ДСТУ Б В.2.7-126
    2011
  • Approximate dilution
    1.4 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,35 - 0,38 l / kg (8.0-9.0 l / bag)
  • Shelf life of the mortar
    not less than 24 hours.
  • Recommended thickness of one layer
    up to 15 mm
  • Strength of the clutch with the base
    not less than 0.3 MPa (28 days)
  • Vapor permeability
    not less than 0.05 mg / mh h. x pa
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    paper bags of 23 kg

Apply the mortar to the wall with a trowel or bucket. Surplus solution to collect rule. Wipe the surface with a wooden or plastic grater after drying. The time from application to grinding depends on the absorbing ability of the base, the consistency of the mortar mixture and the temperature of the air and is determined visually: with a moderate pressing of the finger, the layer of the mortar mixture does not shifted and does not remain on the finger. Further treatment of the plaster surface (finishing spackling, painting) is recommended not earlier than 7 days.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

WARNING!

The lime contained in the mixture has alkaline properties. When working, it is necessary to protect open areas of the skin and eyes. In case of irritation, the affected area should be washed with plenty of water and seek medical advice.

WARNING!

Store in dry containers in unharmed containers.

Download full catalog in PDF format
download