UKEN

Thank you!

Our manager will contact you as soon as possible

SH-6 SLEEVE "START"

Gypsum
description:

SH-6 - a dry spack mixture on the basis of gypsum with inert inorganic fillers and polymeric modifying additives. It is used for gypsum plasterboard bonding and for the starting alignment of concrete and plaster surfaces, filling of stamp, grooves, joints, joints between plasterboard slabs. For internal work.

features:
  • High fission resistance
  •   High adhesion to the base
  •   Used for sticking drywall
  •   Easy to use
order

Usage

Ш-6 - a dry spack mixture on the basis of gypsum with inert inorganic fillers and polymeric modifying additives. It is used for gypsum plasterboard bonding and for the starting alignment of concrete and plaster surfaces, filling of stamp, grooves, joints, joints between plasterboard slabs. For internal work.

preparing basis

The substrate must be strong, even, cleaned of dirt, paint and fragile areas. The surface must be treated with primer G-1, according to the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH SH-6 G.2.ŠT6 DSTU B V.2.7-126
    2011
  • Approximate dilution
    from 1 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,5 - 0,56 l / kg
  • Shelf life of the mortar mixture
    not less than 45 minutes.
  • Recommended thickness of one layer
    from 2 to 15 mm
  • Strength of adhesion to the base (adhesion)
    not less than 0.3 MPa
  • Boundary of compressive strength
    not less than 5 MPa
  • Tensile strength at bending
    not less than 1.2 MPa
  • Shrinkage
    no more than 0.5 mm / m
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    8 months. from the date of manufacture
  • Packaging
    paper bags 14 kg

Put the putty with a wide metal spatula. It is recommended to first fill large cracks and grooves. The mass is superimposed on the walls vertically from the bottom up or vice versa, and on the ceiling - from the window to the depth of the room. After drying, remove the small irregularities by grinding. Further treatment (finishing spackling, gluing of wallpaper) is allowed after a complete drying of the putty surface (humidity less than 2%). After the work is completed, use the dry putty in a bag tightly closed and stored in a dry place.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download