UKEN

Thank you!

Our manager will contact you as soon as possible

SH-2 SHUTTER "FINISH"

Gypsum
description:

SH-2 - a plaster mixture with fillers and modifiers for finishing alignment of concrete and plaster surfaces, drywall sheets. For internal work.

features:
  • White color
  •   Plastic
  •   Easy to use
  •   Super smooth surface
  • Easy to rub
order

Usage

SH-2 - a plaster mixture with fillers and modifiers for finishing alignment of concrete and plaster surfaces, drywall sheets. For internal work.

preparing basis

The substrate must be strong, even, cleaned of dirt, paint and fragile areas. 2 hours Before applying the putty, the surface must be treated with primer G-1, in accordance with the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH SH-2 G.2. SHG1 DSTU B V.2.7-126
    2011
  • Approximate dilution
    from 0,8 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,55 - 0,60 l / kg (7,5 - 8,5 l / bag)
  • Shelf life of the mortar mixture
    not less than 60 minutes.
  • Recommended thickness of one layer
    up to 3 mm
  • Strength of the clutch with the base
    not less than 0,3 MPa
  • Vapor permeability
    not less than 0.07 mg / m х hour. x pa
  • Shrinkage
    no more than 0.5 mm / m
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    8 months. from the date of manufacture
  • Packaging
    polyethylene bags of 2 kg, paper bags of 14 kg

Put the putty with a wide spatula. After drying, remove the small irregularities by grinding. Further processing (painting, pasting the wallpaper) is allowed after a complete drying of the putty surface (humidity is less than 2%). After the work is completed, use the dry putty in a bag tightly closed and stored in a dry place.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download