UKEN

Thank you!

Our manager will contact you as soon as possible

SH-10 SHUTTER "START-FINISH"

Gypsum 2 in 1
description:

SH-10 - high-quality plaster mix with fillers and modifiers of high-level linen for starting and finishing of concrete and plaster surfaces.

features:
  • Start-finish 2 in 1
  •   Does not crack in the thick layer
  •   Ideally smooth and white surface
  •   Plastic and easy to use
order

Usage

SH-10 - high-quality plaster mix with fillers and modifiers of high-level linen for starting and finishing of concrete and plaster surfaces. It is used for embroidery of gypsum boards with the use of reinforcing tape. For internal work.

preparing basis

The substrate must be strong, even, cleaned of dirt, paint and fragile areas. In 2 hours, before applying putty, treat the surface with a primer G-1, according to the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH SH-10 G.2. SHG1 DSTU B V.2.7-126
    2011
  • Approximate dilution
    1 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,52 - 0,58 l / kg (10,4 - 11,6 l / bag)
  • The suitability of the mortar mixture
    not less than 60 minutes.
  • Recommended thickness of one layer
    up to 10 mm
  • Strength of the clutch with the base
    not less than 0,3 MPa
  • Shrinkage
    no more than 0.5 mm / m
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Packaging
    20 kg paper bags
  • Warranty period
    8 months from the date of production

Putty is applied with a wide spatula made of stainless steel or plastic with a thickness of about 3 mm. It is recommended to first fill the cracks and grooves separately from the main layer. The mass is superimposed on the walls vertically from the bottom up or vice versa, and on the ceiling - from the window to the depth of the room. After drying (about 4 hours), remove the small irregularities by grinding abrasive paper or a grid. Further processing (painting, pasting the wallpaper) is allowed after a complete drying of the putty surface (humidity is less than 2%). After the work is completed, use the dry putty in a bag tightly closed and stored in a dry place.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction. The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download