UKEN

Thank you!

Our manager will contact you as soon as possible

SH-0 STOCK ''START''

Gypsum
description:

SH-0 - gypsum-sand mixture with fillers and special additives for leveling non-deformation surfaces (brick, concrete, aerated concrete). For internal work. Designed for manual application.

features:
  • For manual drawing
  •   Reinforced with fiber
  •   Quick set of strength
  •   High fission resistance
order

Usage

SH-0 - gypsum-sand mixture with fillers and special additives for leveling non-deformation surfaces (brick, concrete, aerated concrete). For internal work. Designed for manual application.

preparing basis

The substrate must be strong, even, cleaned of dirt, paint and fragile areas. Surfaces with increased water absorption should be treated with the soil of G-2, according to the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH SH-0 G.2. ST6 DSTU B V.2.7-126
    2011
  • Approximate dilution
    from 12 kg / m2 at a layer thickness of 10 mm
  • Volume of water for mixing
    0,3 - 0,35 l / kg
  • Shelf life of the mortar mixture
    not less than 60 minutes.
  • Recommended thickness of one layer
    up to 25 mm
  • Strength of the clutch with the base
    not less than 0,3 MPa
  • Vapor permeability
    not less than 0.07 mg / m х hour. x pa
  • Shrinkage
    no more than 0.5 mm / m
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    8 months. from the date of manufacture
  • Packaging
    polyethylene bags of 5 kg, paper bags of 30 kg

Apply the mortar mixture evenly on the wall with a trowel or bucket. The surface is aligned with the rule. After the beginning of tzhuvannya (with a slight touch of a finger remains a small dent, the mortar mixture does not remain on the finger), remove the small irregularities, cutting them with a wide spatula. When applying plaster in two layers on the first cut a sharp tool grid depth up to 5 mm for better adhesion of the layers. Subsequent works (finishing spalkevlenie, gluing of wallpaper) to conduct after the complete drying of plaster, which under normal conditions is achieved in 2 - 3 days.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download