UKEN

Thank you!

Our manager will contact you as soon as possible

S-1 STRAINER «UNIVERSAL»

For external and internal works
description:

S-1 - a cement-sand mixture with fillers, microarms and special additives. It has the effect of light alignment and reduced adhesion to the instrument.

features:
  • For external and internal works
  •   The thickness of the layer is from 10 to 70 mm
  •   High strength crack resistance
  •   Used as a lining before stacking
  •   tiles
order

Usage

S-1 - a cement-sand mixture with fillers, microarms and special additives. It has the effect of light alignment and reduced adhesion to the instrument. Used to align the surface to the next coating. Can be used on sloping surfaces. For internal and external work.

preparing basis

The base should be solid, even, dust-free, residual paint and grease. Places of possible leakage (technological openings, gaps) to close carefully. In 2-4 hours before applying the screed, the substrate should be treated with primer G-1 according to the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water with simultaneous mechanical (at medium revolutions) or manual mixing until a loose, homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMMARY S-1 C.1. ST 2 DSTU B V.2.7-126
    2011
  • Approximate dilution
    16 kg / m2 at a layer thickness of 10 mm
  • Volume of water for mixing
    0,16 - 0,18 l / kg (4,0 - 4,5 l / mish.)
  • Shelf life of the mortar mixture
    not less than 2,5 hours.
  • Recommended thickness of one layer
    10-70 mm
  • Compressive strength
    not less than 15 MPa (28 days)
  • Shrinkage
    no more than 2 mm / m
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    paper bags of 25 kg

Spread the mortar evenly on the base layer by 0.5-1 cm above the beacons. Using the rule of uniform, wavy movements align the mixture. 12-18 hours later. The surface can be rubbed with a plastic grater. When applying the mixture in two layers do not allow the entire drying of the previous layer. The surface is suitable for further treatment (gluing of tiles, floor laying) in 7 days. For the best quality surface it is recommended to protect the applied layer from drying, rain and drafts for the first three days. In hot or windy weather, the first three days are recommended periodically to moisten the surface with clean water.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download