UKEN

Thank you!

Our manager will contact you as soon as possible

SH-7 SHEET "FASAD-SHUBA"

Decorative, mineral, grain 1,5 or 2,5 mm
description:

SH-7 - plaster on the basis of white cement with inert inorganic fillers and polymer modified additives for the creation of a decorative texture type "Shuba" on concrete, cement-sand, cement-limestone surfaces, as well as on reinforced layers in the systems of insulation of facades.

features:
  • Based on white cement
  •   For external and internal works
  •   Water-repellent, frost-resistant
  •   Easy to apply and dry
order

Usage

SH-7 - plaster on the basis of white cement with inert inorganic fillers and polymer modified additives for the creation of a decorative texture type "Shuba" on concrete, cement-sand, cement-limestone surfaces, as well as on reinforced layers in the systems of insulation of facades. Plaster is suitable for further painting. For external and internal work.

preparing basis

The base should be even, durable, cleaned of contamination, residues of paints, fats, fragile areas. If necessary, apply a primer G-1 according to the instructions. Reinforced surfaces of thermal insulation systems, lime or lime-cement substrates should be pretreated with GF-1 primer paint 4 hours prior to application of plaster.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manually or mechanically stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again. To ensure a good coverage when mixing, use the entire contents of the bag and consistently observe the same water / mixture ratio.

Technical parameters

Usage guide

  • SUMISH SH-7 CRO.1. ST 4 WHITE DSTU B V.2.7-126
    2011
  • Approximate dilution
    SH-7 (1.5) - 2.0-2.5 kg / m2; Sh-7 (2.0) - 2.8-3.0 kg / m2
  • Volume of water for mixing
    0,20 - 0,22 l / kg (5,0 - 5,5 l / bag)
  • Shelf life of the mortar
    at least 2 hours.
  • Strength of the clutch with the base
    not less than 0,5 MPa
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    paper bags of 25 kg

Apply the mortar using a metal grater or poluterker. After leveling the layer of a given thickness, create the desired surface texture using a plastic grater. The time until the texture is formed (5-10 min.) Is determined visually: plastic grass press slightly to the surface and inspect - the mortar must not stick to the mortar mixture.
The time between the beginning and the end of the invoice formation is limited and depends on the quality of the preparation of the base, the consistency of the mixture, the temperature of the environment and humidity. At t 20 ° C and 60% humidity is not less than 30 minutes. Do not allow the drying of the edges of the applied mortar mixture - when applying the next strip of plaster joints will be noticeable - to perform work using the wet method wet. Painting can be done with any facade paints no earlier than 3 days after applying plaster.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Under the order is made

Ш-7 "Фасад-Шуба" gray in color

Download full catalog in PDF format
download