UKEN

Thank you!

Our manager will contact you as soon as possible

SH-5 SHOULDER "CARROID NORMAL"

Decorative, mineral, grain 2 or 3 mm
description:

SH-5 - plaster mix on the basis of white cement with fillers and polymer modifiers for creating decorative texture of "Koroid" type on concrete, cement-sand, cement-limestone bases, and also on reinforced layers in systems of insulation of facades.

features:
  • For external and internal works
  •   Frost-proof
  •   Economic formula
  •   Based on white cement
order

Usage

SH-5 - plaster mix on the basis of white cement with fillers and polymer modifiers for creating decorative texture of "Koroid" type on concrete, cement-sand, cement-limestone bases, and also on reinforced layers in systems of insulation of facades. Plaster is suitable for further painting. For external and internal works.

preparing basis

The base should be even, durable, cleaned of contamination, residues of paints, fats, fragile areas. Lime or lime-cement bases are recommended to pre-treat with primer G-1, according to the instructions. For 4 hours prior to applying plaster, it is recommended to treat the prepared basis with GF-1 primer paint.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manually or mechanically stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again. To ensure good coverage when mixing, use the entire contents of the bag and consistently observe the same water / mixture ratio.

Technical parameters

Usage guide

  • SUMISH SH-5 COLOR 1. ST 4 WHITE DSTU B V.2.7-126
    2011
  • Tentative breakdown of SH-5 (2)
    2.8-3.2 kg / m2
  • Approximate Sh-5 (3) dispersion
    3.8-4.1 kg / m2
  • Volume of water for mixing
    0,20 - 0,22 l / kg (5,0 - 5,5 l / bag)
  • Strength of the clutch with the base
    not less than 0,5 MPa
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    paper bags of 25 kg

Apply the mortar using a metal grater or poluterker. After leveling the layer to a given grain thickness, create the desired texture of the surface with a plastic grater.
The time until the texture is formed (5-15 min.) Is determined visually: plastic grass press slightly to the surface and inspect - the mortar should not stick to the grinder. The time between the beginning and the end of the invoice is limited and depends on the quality of the preparation of the base, the consistency of the mixture, the temperature of the environment and humidity. At t 20 ° C and 60% humidity is not less than 30 minutes. Do not allow the drying of the edges of the applied mortar mixture - when applying the next strip of plaster joints will be noticeable - to perform work using the wet method wet. Painting can be done with any facade paints no earlier than 3 days after applying plaster.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Under the order is made

Sh-5 Koroid-Normal gray

Download full catalog in PDF format
download