UKEN

Thank you!

Our manager will contact you as soon as possible

K-3 Glue "FASAD PREMIUM"

For the constriction of the reinforcing mesh in the systems of insulation of the facades
description:

K-3 - a cement-sand mixture with fillers, modifiers and micro-reinforcement for the performance of protective reinforcing layer on polystyrene and mineral wool plates at installation of systems of insulation of facades.

features:
  • For external and internal work
  •   Frost resistant, water-repellent
  •   With polymers (RPPs)
  •   Increased strength and adhesion to the surfaces
order

Usage

K-3 - a cement-sand mixture with fillers, modifiers and micro-reinforcement for the performance of protective reinforcing layer on polystyrene and mineral wool plates at installation of systems of insulation of facades.

preparing basis

The base should be solid, even, cleaned of contamination. If foam polystyrene slabs have been exposed to sunlight for a long time, clean the upper damaged layer. Mechanical stripping of mineral wool slabs is not allowed.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions) stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH K-3 C.1.PZ DSTU B V.2.7-126
    2011
  • Approximate dilution
    4.8 kg / m2 at a layer thickness of 3 mm
  • Volume of water for mixing
    0,24 - 0,26 l / kg (6,0-6,5 l / bag)
  • Suitability of a soluble mixture
    not less than 2,5 hours.
  • Compressive strength
    not less than 7 MPa (after 28 days)
  • Strength of grip with the base
    foam polystyrene - not less than 0,08 MPa;
  • Strength of the grip with the base
    mineral wool - not less than 0,015 MPa
  • Water absorption
    no more than 0,5 kg / m2 х hours.
  • Vapor permeability
    not less than 0,1 mg / m x h x Pa
  • Frost resistance
    not less than 75 cycles
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packing
    25 kg paper bags

The implementation of protective reinforcing layer is allowed not earlier than 3 days after sticking the plates.

When performing work recommended the use of a special grater, one side of which has square teeth 10x10 mm. Apply glue to the entire surface of the plate with a smooth side of the grater. Apply a continuous strip to the width of the reinforcing mesh. Form the crests with the toothed side. Hold the grinder at an angle of about 60 ° to the slab. Smoothly squeeze the mesh into glue and smooth to make the grid completely drowned in glue. Do not allow wrinkles and blistering. Overlapping adjacent strips of the grid should be at least 10 cm. Application of subsequent coatings on the created reinforcing layer is allowed not earlier than 3 days. When performing work during the first 3 days, do not allow the drying of the surface.

The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Adhesives are made according to the order

K-3 "Facade Premium" white

Download full catalog in PDF format
download