When fixing the slabs on even bases it is recommended to use a special grater, one side of which has square teeth 10x10 mm. Apply glue to the entire surface of the plate with a smooth side of the grater and form the crests with a toothed. Hold the grinder at an angle of about 60 ° to the slab.
For uneven bases on a foam polystyrene plate, apply 3 to 4 pieces of glue. At 3 cm from the edge of the slab, apply a glue in the form of a roller, leaving a gap of 3 - 4 cm to ensure air circulation.
Attach the stove to the wall, lightly press and level in one plane with other plates. Do not allow glue residues on the ends of the plates. Adhesion is carried out with the spinning of joints.
Fulfillment of protective reinforcing layer is allowed not earlier than 3 days after gluing.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.