UKEN

Thank you!

Our manager will contact you as soon as possible

К-7 "THERMO + 160 ° С" GLUE

Heat resistant for lining fireplaces
description:

K-7 - a cement-sand mixture with fillers and modifiers for facing surfaces exposed to heat (stoves, fireplaces, chimneys, floors with heating, etc.) with a tile size up to 300x300mm.

features:
  • High adhesion to the base
  •   Plastic
  •   Easy to use
  •   For internal and external work
order

Usage

K-7 - a cement-sand mixture with fillers and modifiers for facing surfaces exposed to heat (stoves, fireplaces, chimneys, floors with heating, etc.) with a tile size up to 300x300mm. Suitable for use in the assembly of chimneys.

preparing basis

The base should be solid, level, cleaned of contaminants and fragile areas. Highly absorbing substrates to be treated with a primer of G-1 according to the instructions. If necessary, base to align: - stoves, fireplaces with the same glue (gluing tile in 7 days); - floors with a screw С-1 or self-leveling mixture П-1 (gluing of a tile in 2 days).

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH K-7 CPU.1.3K2 DSTU B V.2.7-126
    2011

Apply a thin layer of glue to the prepared substrate and form a toothed spatula. Spatula hold at an angle of about 60 ° to the base. Apply the tile, pressing it to the glue with a light sliding motion. When facing a stone with a rough foundation or a tile larger than 300x300mm apply a technique of two-sided gluing: apply a solution mixture with a thin layer (about 1mm) and on the tile.

Recommended spatula teeth size:
Tile Teeth
Up to 150x150 6x6
Up to 200x200 8x8
Up to 300x300 10x10
You can adjust the position of the tile within 10 minutes. In dry and windy weather it is recommended to apply glue on small areas. Tearing of the joints and moderate surface operation is possible after 48 hours. Do not moisten the tile before use.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

WARNING!

Store in dry containers in unharmed containers.

Download full catalog in PDF format
download