Thank you!

Our manager will contact you as soon as possible


For marble

K-6 is a white-colored cement-sand mixture with fillers and modifiers for gluing marble slabs, mosaics and other light stone rocks.

  • White color
  •   High adhesion to bases with low water absorption
  •   Easy to use


K-6 is a white-colored cement-sand mixture with fillers and modifiers for gluing marble slabs, mosaics and other light stone rocks. Resistant to deformations, temperature fluctuations, variable water impact. Suitable for floors with heating (with any type of heating elements), for the revetment of pools, fountains, basements, both inside and outside of the premises.

preparing basis

The base should be solid, level, cleaned of contaminants and fragile areas. Inequalities of more than 10 mm correct cement-sand solution a day before the work began. If necessary, strengthen the soil of the G-1, according to the instructions.


Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH K-6 BLUE D.1.3K4 DSTU B V.2.7-126
  • Approximate dilution
    from 1,55 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,24 - 0,28 l / kg (6.0-7.0 l / bag)
  • Shelf life of the mortar mixture
    not less than 2,5 hours.
  • Correction time
    not less than 10 min.
  • Open time
    at least 20 min.
  • Strength of the clutch with the base
    not less than 1.2 MPa
  • Time of possible technological movement
    no later than 48 hours.
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    paper bags of 25 kg

Apply a thin layer of glue to the prepared substrate and form a toothed spatula. Spatula hold at an angle of about 60 ° to the base. Apply the tile, pressing it to the glue with a light sliding motion. When facing with a rough stone or tile over 300x300 mm, apply a two-sided bonding technique: apply a glue with a thin layer (about 1 mm) and on a tile.

Recommended spatula teeth size:
Tile Teeth
Up to 150x150 6x6
Up to 200x200 8x8
Up to 300x300 10x10
More than 300x300 12 x 12
You can adjust the position of the tile within 10 minutes. In dry and windy weather it is recommended to apply glue on small areas. Tearing of the joints and moderate surface operation is possible after 48 hours. Do not moisten the tile before use.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.


Store in dry containers in unharmed containers.

Download full catalog in PDF format