UKEN

Thank you!

Our manager will contact you as soon as possible

K-4 PREMIUM GLUE

For ceramic granite, granite, stone and warm floors
description:

К-4 - a cement-sand mixture with fillers and modifiers for gluing of any kinds of materials: ceramic tile, ceramic granite, mosaic, greas, decorative stone.

features:
  • For external and internal work
  •   Elastic
  •   Water-repellent, frost-resistant
  •   Increased adhesion to any of the bases
order

Usage

К-4 - a cement-sand mixture with fillers and modifiers for gluing of any kinds of materials: ceramic tile, ceramic granite, mosaic, greas, decorative stone. Resistant to deformations, temperature fluctuations, variable water impact. Suitable for floors with heating (with any type of heating elements), for facing of pools, fountains, basements of buildings, staircase marches, both inside and outside of the premises.

preparing basis

The base should be solid, level, cleaned of dirt and fragile areas. Inequalities of more than 10 mm correct cement-sand solution a day before the work began. If necessary, strengthen the soil of the G-1, according to the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions) stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH K-4 D.1.3K4 DSTU B V.2.7-126
    2011
  • Approximate dilution
    from 1.5 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,24 - 0,28 l / kg (6,0-7,0 l / bag)
  • Suitability of a soluble mixture
    not less than 2,5 hours.
  • Correction time
    not less than 10 min.
  • Open time
    at least 20 min.
  • Strength of the clutch with the base
    not less than 1.2 MPa
  • Time of possible technological movement
    no later than 48 hours.
  • Performance temperature
    from + 5 ° C to +30 ° C
  • Guaranteed storage life
    12 months. from the date of preparation
  • Packaging
    paper bags 25 kg

Apply a thin layer of glue to the prepared substrate and form a toothed spatula. Spatula hold at an angle of about 60 ° to the base. Apply the tile, pressing it to the glue with a light sliding motion. When facing with a rough stone or tile over 300x300 mm, apply a two-sided bonding technique: apply a solution mixture with a thin layer (about 1 mm) and a tile.

Recommended spatula teeth size:
Tile Teeth
Up to 150x150 6x6
Up to 200x200 8x8
Up to 300x300 10x10
More than 300x300 12x12
You can adjust the position of the tile within 10 minutes. In dry and windy weather, it is recommended to apply a solution mixture to small areas. Warping and moderate surface operation are possible after 48 hours. Do not moisten the tile before use.

The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download