UKEN

Thank you!

Our manager will contact you as soon as possible

К-0 КЛЕЙ «NORMAL»

For ceramic tiles
description:

K-0 - cement-sand mixture with fillers and modifiers for wall and floor tiling with water absorption tile of not less than 3%. The recommended tile size is up to 300x300 mm.

features:
  • New economic formula
  •   Stable on vertical surfaces
  •   Hardy
  •   Plastic
order

Usage

K-0 - cement-sand mixture with fillers and modifiers for wall and floor tiling with water absorption tile of not less than 3%. The recommended tile size is up to 300x300 mm. The mixture is suitable for preliminary alignment of walls and masonry works.

preparing basis

The base should be solid, level, cleaned of contaminants and fragile areas. If it is necessary to correct the inequalities with the same adhesive the day before the work began. Bases with high water absorption moisten with water. If necessary, strengthen the soil of the G-1, according to the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • SUMISH K-0 D.1.3K1 DSTU B V.2.7-126
    2011
  • Approximate dilution
    from 1.5 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,20 - 0,22 l / kg (5,5 l / bag)
  • Shelf life of the mortar mixture
    not less than 2,5 hours.
  • Tile offset
    not more than 0.5 mm
  • Correction time
    not less than 10 min.
  • Open time
    at least 20 min.
  • Strength of the clutch with the base
    not less than 0,5 MPa
  • Time of possible technological movement
    no later than 48 hours.
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    paper bags 25 kg

Apply a thin layer of glue to the prepared substrate and form a toothed spatula. Spatula hold at an angle of about 60 ° to the base. Apply the tile, pressing it to the glue with a light sliding motion. When facing a tile with a rough foundation or a tile larger than 300x300 mm, apply a two-sided bonding technique: apply a glue with a thin layer (about 1 mm) and on a tile.

Recommended spatula teeth size:
Tiles up to 150x150 - 6x6 teeth
Tile to 200x200 - 8x8 teeth
Tile to 300x300 - teeth 10x10
You can adjust the position of the tile within 10 minutes. In a dry, hot room (t above 20 ° C) it is recommended to apply glue to small areas. Tearing of the joints and moderate surface operation is possible after 48 hours. Do not moisten the tile before use.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

WARNING!

Store in dry containers in unharmed containers.

Download full catalog in PDF format
download