UKEN

Thank you!

Our manager will contact you as soon as possible

SH-8 SUSPICLE "FASAD-FINISH"

Facade
description:

Sh-8 - a dry spatula blend on the basis of white cement with fillers, modifiers and special additives for finishing the alignment of concrete and plaster surfaces, drywall, etc. inside and out of the premises, resistant to moisture.

features:
  • Snow white
  •   Water-repellent
  •   Frost-proof
  •   Easy to use
order

Usage

Sh-8 - a dry spatula blend on the basis of white cement with fillers, modifiers and special additives for finishing the alignment of concrete and plaster surfaces, drywall, etc. inside and out of the premises, resistant to moisture. Suitable for decorative textured surfaces with a height difference of 3-5 mm.

preparing basis

The substrate must be strong, even, cleaned of dirt, paint and fragile areas. If necessary, treat the soil with the G-1 according to the instructions.

preparing

Gradually pour the mixture into a vessel with a measured amount of pure water while simultaneously manual or mechanical (at low revolutions), stirring until a homogeneous mass is obtained. Stand for 5 minutes and mix again.

Technical parameters

Usage guide

  • MIXTURE SH-8 C.1. Sh Z.1 WHITE DSTU B V.2.7-126
    2011
  • Approximate dilution
    from 0,25 kg / m2 at a layer thickness of 1 mm
  • Volume of water for mixing
    0,35 - 0,40 l / kg (7,0 - 8,0 l / bag)
  • Shelf life of the mortar
    at least 2 hours.
  • Recommended thickness of one layer
    up to 3 mm
  • Frost resistance
    not less than 75 cycles
  • Strength of the clutch with the base
    not less than 0,5 MPa
  • Performance temperature
    from + 5 ° C to + 30 ° C
  • Guaranteed storage life
    12 months. from the date of manufacture
  • Packaging
    20 kg paper bags

Apply the mortar to the base using a spatula. Smooth the surface with felt rubbing or after drying, sandpaper, grid or grinding sponge. When creating a decorative surface uniformly applied layer of mortar mixture to handle a texture roller or a special tool.
For the best quality surface it is recommended to protect the applied layer from drying, rain and drafts for the first three days. In hot or windy weather, the first three days are recommended periodically to moisten the surface with clean water. The resulting surface can be painted with any paint for walls and ceiling after the hardening of the putty, but not earlier than 7 days after application.
The technical characteristics of the mixture and the recommendations for use were determined under standard conditions (t = 20 ° С, humidity 65%) and in real conditions may vary.
The manufacturer guarantees the conformity of the products with the declared technical characteristics, subject to the rules of transportation, storage and compliance with this instruction.
The manufacturer does not bear responsibility for the unauthorized use of the material.

Download full catalog in PDF format
download